Black & Decker BDP2600 Manuel d'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
17 - ENG
TROUBLE SHOOTING GUIDE
PROBLEM CAUSE CORRECTION
Engine will
not start (see
Engine Manual
for further
engine
troubleshoot-
ing)
No fuel. Add Fuel.
Pressure builds up after two
pulls on the recoil starter or
after initial use.
Squeeze gun trigger to relieve
pres sure.
Choke lever in the "No Choke"
position.
Move choke to the "Choke"
po si tion.
Spark plug wire not attached. Attach spark plug wire.
Engine switch in OFF
po si tion.
Place engine switch in on posi-
tion.
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat for a
long period of time.
Move choke to the "No Choke"
po si tion.
Fuel valve closed. Move the fuel valve lever to the
OPEN position.
No or low
pressure
(initial use)
Spray wand not in high pres-
sure.
See How to Use Spray Wand
instructions in the Operation
Section.
Low water supply. Water supply must be at least
5 GPM @ 20 psi.
Leak at high pressure hose
fitting.
Repair leak. Apply sealant tape
if necessary.
Nozzle obstructed. See Nozzle Cleaning instruc-
tions in the Maintenance sec-
tion.
Water filter screen clogged. Remove and clean filter.
No or low
pressure
(initial use)
Air in hose. Turn off the engine, then the
water source. Disconnect the
water source from the pump
inlet and turn the water source
on to remove all air from the
hose. When there is a steady
stream of water present, turn
water source off. Re- con nect
water source to pump inlet and
turn on wa ter source. Squeeze
trigger to re move re main ing air
Choke in the “Choke” position. Move choke to the “No Choke”
po si tion.
High pressure hose is too
long.
Use high pressure hose under
100 feet (30 m).
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Commentaires sur ces manuels

Pas de commentaire