Black & Decker BCE27 Manuel d'utilisation et d'entretien télécharger pdf (Page 6)

English

• Make sure there is a suitable power outlet (115 volts, 15 amps outlet)

with proper grounding to power the refrigerator.

• Avoid the use of three prong adapters or cutting off the third

grounding prong in order to accommodate a two prong outlet. This is

a dangerous practice since it provides no effective grounding for the

refrigerator and may result in shock hazard.

• Avoid the use of an extension cord because of potential safety hazards

under certain conditions. If it is necessary to use an extension cord,

use only a 3-wire extension cord that has a 3-blade grounding plug

and a 3-slot outlet that will accept the plug. The marked rating of the

extension cord must be equal to or greater than the electrical rating of

the appliance. DO NOT USE EXTENSION CORD LONGER THAN

12 FT.

• Do not install your refrigerator in any location not properly insulated

or heated, e.g. garage, etc. Your refrigerator was not designed to

operate in temperature settings below 55˚ Fahrenheit.

• Select a suitable location for the refrigerator on a hard even surface

away from direct sunlight or heat source, e.g. radiators, baseboard

heaters, cooking appliances, etc. Any floor unevenness should be

corrected with the leveling legs located on the front bottom corners of

the refrigerator.

Electrical Requirement

Installation Limitations

Use of Extension Cords

WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD

WARNING: USE OF EXTENSION CORDS- POTENTIAL SAFETY HAZARD

Door Alignment (see fig. # 1)

1. Remove hinge cover screw.

2. Remove the top hinge cover.

3. Loosen the top hinge screws using a Phillips head

screwdriver.

4. Adjust the door or put a spacer

in between and tighten the screws.

5. Replace the top hinge cover.

fig. 1

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Pas de commentaire

Black & Decker BCE27 Manuel d'utilisation et d'entretien Page 6