Black & Decker FP6010 Manuel d'utilisation et d'entretien télécharger pdf (Page 10)

HELPFUL TIPS WHEN USING

THE DICING DISK

• Operate the dicing disk on LOW speed.

• It is recommended to stop dicing when workbowl is 60% full.

• Blade must be removed from the top of the disk before using the cleanout

tool.

• Cut the ends of food to be diced off for most uniform dice.

• For small and soft foods, such as strawberries, use the smallest feed chute

for best results.

• When dicing multiple ingredients, dice softer foods ﬁrst and end with

hardest food.

• When dicing soft cheese, chill or freeze cheese prior to dicing.

• Not recommended for dicing corned beef, raw meat, or chicken.

• When dicing tomatoes, it is recommended to seed and peel them ﬁrst.

• Firm, seedless cucumbers work best.

USING THE SLICING DISK (GREEN)

Important: The slicing disk can only be used with the large workbowl. Only

run the processor on MEDIUM or LOW speed when using the slicing disk. DO

NOT use slicing disk with small workbowl.

1. Lock the large workbowl into position on base.

2. Carefully place the slicing disk onto center post in workbowl. You may

need to rotate disk slightly until it ﬁts onto post.

3. Place lid on workbowl and lock into place by rotating counterclockwise. Place

the food pushers into the feed chute. Put ingredients in the feed chute and

guide food down towards blade with the food pusher.

Note: Position slicing disk just to the right of the feed chute. This allows the

blade a full rotation before contacting the food.

4. To adjust the slicing thickness, move the lever at

the base of feed chute forward and backwards to

desired thickness setting (1-5mm). Turn the lever

counterclockwise towards the front of the food

processor for thicker slices and clockwise towards

the back of the food processor for thinner slices. You

are able to adjust thickness while the processor is

running. (L)

5. Press MEDIUM or LOW speed to slice; press lightly but ﬁrmly on food

pusher to guide food through processor.

Note: Heavy pressure on the pusher does not speed the work; use the pusher

only as a guide. Let the processor do the work. Pushing too hard may result in

inconsistent slicing thickness.

Note: It is possible to change the thickness of your slices by changing

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Pas de commentaire

Black & Decker FP6010 Manuel d'utilisation et d'entretien Page 10