Black & Decker BD168F Manuel d'instructions télécharger pdf (Page 11)

11 - ENG

N003333

To Inspect the Elements

1. Remove the wing nut (Q) and the

air filter cover (R).

S

T

Q

Q

R

2. Remove the second wing nut (Q)

and remove the filter (T).

3. Remove the foam-type pre-filter

(S) from the filter (T).

4. Inspect foam and paper elements.

Replace them if damaged.

To Clean the Elements

Foam element: Wash element in

warm, soapy water. Then saturate it in

clean engine oil. Squeeze the element

to remove excess oil.

Paper element: Clean element by tap-

ping gently to remove dust. Use com-

pressed air to blow off dust.

WARNING: When using com-

pressed air, user always must wear

eye protection that conforms to ANSI

Z87.1. (CAN/CSA Z94.3).

Never use oil. Always blow the element

from the inside. If using compressed

air keep the air pressure less than 30

psi.

Place the foam pre-filter over the paper

element and reinstall it onto the engine.

Oil

WARNING: Hot surfaces. Risk of

burn. Engine and surrounding parts

are very hot, do not touch (see the Hot

Surfaces identified in Figure 1). Allow

engine to cool prior to servicing.

To Check Oil (Fig. 1)

1. Place unit on a flat level surface.

2. Remove oil fill/dipstick (C) and

wipe clean.

3. Reinsert oil fill/dipstick fully into

oil fill port and tighten. Allow oil to

collect on the dipstick for a few

seconds.

4. Remove oil fill/dipstick to read oil

level. If oil falls below top of pat-

tern on dipstick, add oil. NOTE:

Patterns (CC) may differ according

to engine.

U

U

NOTE: When filling the crankcase,

allow the oil to flow very slowly. If

the oil is added too quickly, it will

overflow and appear to be full.

5. Replace dipstick and tighten

securely.

To Change Oil (Fig. 1)

NOTE: Engine oil contains substances

that are regulated and must be dis-

posed of in accordance with local,

state, provincial and federal laws and

regulations.

1. Disconnect spark plug wire.

2. Locate a suitable container under

oil drain plug (D).

3. Remove the oil fill/dipstick (C)

from crank case.

4. Remove the oil drain plug (D).

5. Allow ample time for all oil to drain

out.

6. Install the oil drain plug.

7. Fill with recommended oil, refer

to Oil Recommendations under

Assembly.

8. Replace dipstick and tighten

securely.

9. Reconnect spark plug wire.

10. Dispose of oil according to

local, state and federal laws and

regulations.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Commentaires sur ces manuels

Pas de commentaire