Black & Decker Trimmer NHT518 Manuel d'utilisateur télécharger pdf (Page 7)

been dropped, run over or damaged in any way (i.e., pierced with a

nail, hit with a hammer, stepped on). Damaged battery packs should

be returned to service center for recycling.

CAUTION: When not in use, place tool on its side on a stable

surface where it will not cause a tripping or falling hazard. Some

tools with large battery packs will stand upright but may be easily

knocked over.

Battery Cap Information

A battery storage and carrying cap is provided for use whenever the

battery is out of the tool or charger. Remove cap before placing

battery in charger or tool.

WARNING: Fire hazard. Do not store or carry

battery so that metal objects can contact exposed battery

terminals. For example, do not place battery in aprons, pockets, tool

boxes, product kit boxes, drawers, etc., with loose nails, screws,

keys, etc. Transporting batteries can possibly cause fires if the

battery terminals inadvertently come in contact with conductive

materials such as keys, coins, hand tools and the like. The US

Department of Transportation Hazardous Material Regulations (HMR)

actually prohibit transporting batteries in commerce or on airplanes

(i.e., packed in suitcases and carry-on luggage) UNLESS they are

properly protected from short circuits. So when transporting individual

batteries, make sure that the battery terminals are protected and well

insulated from materials that could contact them and cause a short

circuit.

IMPORTANT CHARGING SAFETY

INSTRUCTIONS

CHARGING PROCEDURE

THE BATTERY PACK IS NOT FULLY CHARGED AT THE

FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS

BEFORE USE.

The charger is designed to use standard household 120 volt 60 Hz

power.

1. Plug the charger into any standard 120 Volt

60 Hz electrical outlet (figure 1).

2. Slide the charger onto the battery pack as

shown in figure 2 and let the battery pack

charge initially for 9 hours. After the initial

charge, under normal usage, your battery

pack should be fully charged in 6 to 9 hours.

2a) During charging the green LED will appear.

2b) When charging is complete the green LED

will go off.

3. Unplug charger, and remove the battery pack.

Place the battery pack into the tool until it

“clicks” into place.

NOTE: To remove the battery pack, press

down on the release button on the back of the

battery pack and slide out (figure 3).

IMPORTANT CHARGING NOTES

1. After normal usage, your battery pack should be fully charged in

6 to 9 hours. If the battery pack is run-down completely, it may

take up to 9 hours to become fully charged. Your battery pack

was sent from the factory in an uncharged condition. Before

attempting to use it, it must be charged for at least 9 hours.

2. DO NOT charge the battery pack in an air temperature below

Battery Cap

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Black & Decker Trimmer NHT518 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Taille-haie sans fil Black & Decker Trimmer NHT518