Black & Decker Trimmer NHT518 Manuel d'utilisateur télécharger pdf (Page 4)

Extension Cord

Make sure your extension cord is in good condition. When using an

extension cord be sure it is heavy enough to carry the current your

product will draw. An undersized extension cord will cause a drop in

line voltage resulting in loss of power and overheating. The following

table shows the correct size to use depending on cord length and

nameplate ampere rating. If in doubt, use the next heavier gauge.

The smaller the gauge number, the heavier the cord.

Double Insulation

Double insulated tools are constructed throughout with two

separate layers of electrical insulation or one double thickness

of insulation between you and the toolʼs electrical system.

Tools built with this insulation system are not intended to be

grounded. As a result, your tool is equipped with a two prong

plug which permits you to use extension cords without concern

for maintaining a ground connection. NOTE: Double insulation does

not take the place of normal safety precautions when operating this

tool. The insulation system is for added protection against injury

resulting from a possible electrical insulation failure within the tool.

REPLACEMENT PARTS: When servicing all tools, USE IDENTICAL

REPLACEMENT PARTS. Repair or replace damaged cords.

WARNING: To reduce the risk of electrical shock;

do not expose to rain, do not use on wet surfaces. Store indoors.

SAVE THESE INSTRUCTIONS

WARNING: Some dust created by this product

contains chemicals known to the State of California to cause cancer,

birth defects or other reproductive harm. Some examples of these

chemicals are:

• compounds in fertilizers

• compounds in insecticides, herbicides and pesticides

• arsenic and chromium from chemically treated lumber

To reduce your exposure to these chemicals, wear approved safety

equipment such as dust masks that are specially designed to filter out

microscopic particles.

The label on your tool may include the following symbols.

V................volts A ....................amperes

Hz..............hertz W ..................watts

min ............minutes ..................alternating current

..........direct current

o ..................no load speed

..............

Class II Construction

..................earthing terminal

............safety alert symbol .../min ............revolutions

per minute

Minimum Gage for Cord Sets

Volts Total Length of Cord in Feet

120V 0-25 26-50 51-100 101-150

(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

240V 0-50 51-100 101-200 201-300

(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)

Ampere Rating

More Not more American Wire Gage

Than Than

0-6 18 16 16 14

6-10 18 16 14 12

10 - 12 16 16 14 12

12 - 16 14 12 Not Recommended

1 2 3 4 5 6 7 8 9 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Black & Decker Trimmer NHT518 Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Taille-haie sans fil Black & Decker Trimmer NHT518