8
ENGLISH
Never use a light socket.
OVERVIEW (fig. A)
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
4. Chuck
5. Two-gear selector
6. Battery charge indicator
(HP120/HP144/HP180)
7. Bit holder
8. Side handle (HP180K)
9. Battery
10. Battery release button
11. Charger
12. Charging indicator
13. End of charge indicator
ASSEMBLY
Fitting and removing the battery (fig. B)
To fit the battery (9), line it up with the
receptacle on the tool. Slide the battery into
the receptacle and push until the battery snaps
into place.
To remove the battery, push the release
button (10) while at the same time pulling the
battery out of the receptacle.
Fitting and removing a drill bit or screwdriver
bit (fig. A & C)
This tool is fitted with a keyless chuck to allow for
an easy exchange of bits.
Lock the tool by setting the forward/reverse
slider (2) to the centre position (fig. A).
Open the chuck by turning the front part (15)
with one hand while holding the rear part (16)
with the other (fig. C).
Insert the bit shaft (17) into the chuck.
Firmly tighten the chuck by turning the front
part (15) with one hand while holding the rear
part (16) with the other.
This tool is supplied with a double-ended
screwdriver bit in the bit holder (7) (fig. A).
To remove the screwdriver bit from the bit
holder, lift the bit from the recess.
To store the screwdriver bit, firmly push it into
the holder.
HP180K - Fitting the side handle (fig. A)
Loosen the side handle (8) by turning it
counterclockwise.
Slide the side handle over the chuck and onto
the housing.
Tighten the side handle by turning it clockwise.
USE
Let the tool work at its own pace.
Do not overload.
Charging the battery (fig. E)
The battery needs to be charged before first use
and whenever it fails to produce sufficient power
on jobs that were easily done before.
A new battery, or a battery that has not been used
for an extended period of time, achieves full
performance only after approx. 5 charging and
discharging cycles. The battery may become warm
while charging; this is normal and does not
indicate a problem.
Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Recommended charging temperature:
approx. 24 °C.
After normal use, a charging time of 3 hours
will provide sufficient power for most applications.
However, further charging passed to 180 minutes
could significantly increase the use time,
depending on the battery and charging
conditions.
To charge the battery (9), remove it from the
tool and insert it into the charger (11).
The battery will only fit into the charger in one
way. Do not force. Be sure that the battery is
fully seated in the charger.
Plug in the charger.
Check if the red charging indicator (12) lights
up. If the green end of charge indicator (13)
lights up now instead, the battery is too hot
and cannot be charged. If this happens,
remove the battery from the charger, let the
battery cool down for approx. 1 hour and
re-insert it.
(14 pages)
(32 pages)
(12 pages)
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels