Black & Decker ELECTROMATE VEC027BD Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
9
CARE AND MAINTENANCE
CAUTION
If the cord, wires, or cables become damaged, return the entire unit
to Vector Manufacturing immediately for service/repair.
Replacement Parts
For replacement parts (bulbs, batteries, fuses, etc.), contact Customer Service, toll-
free, at (800) 618-5178.
Battery Replacement/Disposal
It is recommended that the unit be returned to Customer Service
for battery replacement.
This unit contains a maintenance-free, non-spillable, sealed lead-
acid battery. This battery is fully recyclable and should be
accepted at any location that accepts common automotive
starter batteries. Examples of places that accept these batteries
are: county or municipal recycling drop-off centers, scrap metal
dealers and retailers who sell automotive replacement lead acid
starter batteries.
WARNINGS
Do not dispose of the battery in fire, as this may result in an explosion.
Before disposing of the battery, protect exposed terminals with
heavy-duty electrical tape to prevent shorting (shorting can result in
injury or fire).
Do not expose battery to fire or intense heat, as it may explode.
Fuse Replacement (DC Accessory Adapter)
1. Remove plug from accessory outlet. Remove the gold cap by turning counter-
clockwise and lifting off.
2. Remove center pin and spring. Remove fuse.
3. Replace fuse with same type and size fuse (8 amp).
4. Replace center pin and spring inside plug.
5. Replace gold cap by turning clockwise.
8
Inflating Products Without a Valve Stem
Inflation of other items requires use of one of the adapters (nozzles).
1. Insert appropriate adapter (e.g. needle) into connector (chuck) and close thumb
latch.
2. Insert adapter (e.g. needle) into item to inflate.
3. Slide inflator switch to ON.
4. Refer to the following table for approximate filling pressure and time. Small items
such as volleyballs, footballs, etc. inflate very rapidly.
5. Slide inflator switch to OFF.
6. Remove adapter from item and store properly.
Typical Inflation Times
Inflation pressure (psi) Approx. Filling time
Vehicle and trailer tires
155/80R 13" 26 2.5 min.
185/70R 14" 30 4.5 min.
235/75R 16" 30 6.5 min.
235/70R 17" 42 16 min.
Bicycle tires
27" X 1" (racing) 90 40 sec.
Football 13 24 sec.
Basketball 10 20 sec.
Volleyball 5 6 sec.
WARNING
Always follow tire manufacturers recommendations for pressure on
item to be inflated.
VEC027BD_ManualEN_122805 12/28/05 2:37 PM Page 8
Vue de la page 6
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire