Black & Decker ELECTROMATE VEC027BD Manuel d'utilisateur télécharger pdf (Page 6)

USING THE EMERGENCY AREA LIGHT

The Area Light is controlled by an ON/OFF pushbutton. Make sure the light is turned

OFF when the unit is being recharged or stored.

USING THE TIRE INFLATOR

Read Instructions Carefully to Avoid Possible Injury or Property

Damage.

The built-in 12 volt DC inflator is the ultimate inflator for all vehicle tires, trailer tires

and recreational inflatables. Three different sized nozzles are supplied. Each nozzle

clips on the end of the standard tire valve connector attached to the free end of the

inflator hose. The inflator hose with tire fitting is stored in a retaining channel between

the jumper cable channels on the rear of the unit. The ON/OFF switch is located on

the front of the unit. The inflator can operate long enough to fill up to 3 average sized

tires before the battery must be recharged. The inflator may be used by removing the

air hose from the storage hatch and, if required, fitting the appropriate nozzle to the

air hose. Return the hose to the storage compartment after use.

Note: Thermo-protection device shuts down the unit when the unit overheats and

restarts once the unit has reached a safe operating temperature.

WARNING

The inflator is capable of inflating up to 120 pounds per square inch

(psi) pressure. To avoid over inflating, carefully follow instructions on

articles to be inflated. Never exceed recommended pressures. Always

check pressure with the pressure gauge. Never leave the inflator

unattended while in use. Bursting articles can cause serious injury.

CAUTION

Do not operate inflator continuously for extended periods of time

(approx. 15 minutes, depending on the ambient temperature), as it

may overheat. In such event, inflator will shut down and restart after a

cooling period of approximately 15 minutes.

Inflating Products With a Valve Stem

1. Place standard connector (chuck) on valve stem.

2. Push connector toward valve stem and close thumb latch.

Note: Make sure connector is pushed onto valve stem as far as possible

before closing thumb latch.

3. Slide inflator switch to ON.

4. Check pressure with the pressure gauge.

5. When desired pressure is reached, slide the inflator switch to OFF; open thumb

latch and remove connector from valve stem.

6. Store inflator hose and tire fitting in storage compartment.

USING THE 120 VOLT AC POWER SUPPLY

The 120 Volt AC Power Supply is designed for maintaining today's modern lifestyle

while traveling in vans, RVs, automobiles, trucks, or vehicles that have a 12 volt DC

battery power supply and a means to recharge those batteries. The

Electromate

™

Plus 300

comes with:

1. AC ON/OFF Switch — Slide switch to turn the AC Power Supply ON and OFF.

2. 120 Volt AC Power Outlets

3. AC Power Supply “ON” Status Indicator — green LED lights when AC outlet is

turned on; green LED flashes on and off when faulted.

4. AC Power Ground Fault Circuit Interrupt (GFCI) — a 3-prong outlet for 120 volt

AC appliances which shuts down inverter if leakage or ground fault current is

detected.

5. Internal protective circuits including:

• Overload and over-temperature shutdown (activated if AC output exceeds 300

watts)

• AC short-circuit shutdown

• Low voltage shutdown

• A new cooling technology that more efficiently cools the power transistors and,

combined with soft start, dramatically increases reliability and product life

AC Power Supply Controls and Indicators

The illustration below details the AC Power Supply front panel. Air vents keep the unit

from overheating. An ON/OFF switch turns the AC power circuitry on and off. The

ON/OFF switch can also be used to reset the AC power after shutdown due to

overvoltage, overload or over-temperature condition. The “ON” status indicator lights

when the AC power supply is on. The AC outlets (covered when not in use) supply

power to AC appliances.

AC Power Supply Front Panel

AC Power Supply Operation

1. Turn power switch to ON (the power indicator lights).

2. Plug in appliance and turn the appliance on.

Note: The AC power supply shuts down automatically when the battery voltage level

is too low. If the green LED flashes, a faulty condition such as an overload,

overheating or short circuiting has occurred. Turn the AC Power Supply OFF and

unplug the appliance. Wait a few minutes, then turn power back ON.

AC POWER SUPPLY

“ON” STATUS

INDICATOR

AIR VENTS

AC POWER SUPPLY

ON/OFF SWITCH

120 VOLT AC

OUTLETS

VEC027BD_ManualEN_122805 12/28/05 2:37 PM Page 6

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Black & Decker ELECTROMATE VEC027BD Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Chargeurs de batteries pour voitures Black & Decker ELECTROMATE VEC027BD