Black & Decker G730 Manuel d'instructions télécharger pdf

Important Safety Instructions

• SAVE THESE INSTRUCTIONS. This manual contains important safety and operating

instructions for SPMVC battery charger.

•

Before using charger, read all instructions and cautionary markings on (1) charger, (2)

battery pack, and (3) product using battery pack.

DANGER: 120 volts present at charging terminals. Do not probe with conductive objects.

Danger of electric shock or electrocution.

DANGER: If battery pack case is cracked or damaged, do not insert into charger. Danger

of electric shock or electrocution.

DANGER: Never attempt to open the battery pack for any reason. If the plastic housing of

the battery pack breaks or cracks, return to a service center for recycling.

WARNING: Donʼt allow any liquid to get inside charger. Electric shock may result.

CAUTION: To reduce risk of injury, charge only Black & Decker rechargeable batteries.

Other types of batteries may burst, causing personal injury and damage.

• To facilitate the cooling of the battery pack after use, avoid placing the charger or battery

pack in a warm environment such as in a metal shed, or an uninsulated trailer.

• Do not expose charger to rain or snow.

• Use of an attachment not recommended or sold by Black & Decker may result in risk of

fire, electric shock, or injury to persons.

• This charger is not intended for any uses other than charging Black & Decker rechargeable

batteries. Any other uses may result in risk of fire, electric shock or electrocution.

• To reduce risk of damage to electric plug and cord, pull by plug rather than cord when

disconnecting charger.

• Make sure cord is located so that it will not be stepped on, tripped over, or otherwise

subjected to damage or stress.

• An extension cord should not be used unless absolutely necessary. Use of improper

extension cord could result in risk of fire, electric shock, or electrocution. If an extension

cord must be used, make sure:

• That the pins on plug of extension cord are the same number, size and shape of those

of plug on charger.

• That extension cord is properly wired and in good electrical condition and the wire size

is large enough for AC ampere rating of charger as specified below.

An extension cord must have adequate wire size (AWG or American Wire Gauge) for

safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that

is, 16 gauge has more capacity than 18 gauge. When using more than one extension to

make up the total length, be sure each individual extension contains at least the minimum

wire size.

Recommended Minimum Wire Size for Extension Cords

Total Length of Cord

25 ft. 50 ft. 75 ft. 100 ft. 125 ft. 150 ft. 175 ft.

7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m 53.3 m

Wire Size AWG

18 18 16 16 14 14 12

• The charger is ventilated through slots in the housing. Do not place any object on top of

charger or place the charger on a soft surface that might block the ventilation slots and result

in excessive internal heat. Place the charger in a position away from any heat source.

• Do not operate charger with damaged cord or plug — have them replaced immediately.

• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged

in any way; take it to an authorized service center.

• Do not disassemble charger; take it to an authorized service center when service or repair is

required. Incorrect reassembly may result in risk of electric shock, electrocution or fire.

• The charger is designed to operate on standard120 VAC, 60Hz household electrical power.

Do not attempt to use it on any other voltage.

• To reduce risk of electric shock, unplug charger from outlet before attempting any cleaning.

Removing the battery pack will not reduce this risk.

• NEVER attempt to connect 2 chargers together.

• DO NOT store or use the tool and battery pack in locations where the temperature may reach

or exceed 105°F (such as outside sheds or metal buildings in summer).

SAVE THESE INSTRUCTIONS

ntroduction

Your charger is designed to use standard 120 volt AC, 60 Hz power. Do not use DC or any

other voltage. Charge time is 90 to 120 minutes depending on battery pack type and condition.

Charging Procedure

1. Plug the charger into an appropriate outlet.

2. Insert the battery pack into the charger (Fig.1) . Be sure the pack is fully

seated in the charger. The red (charging) light will blink continuously indicating

that the charging process has started.

3. The completion of charge will be indicated by the red light remaining ON

continuously. The pack is fully charged and may be used at this time or left in the

charger.

Charge Indicators

Replace Pack:

These chargers are designed to detect certain problems that can arise with battery packs which

would be indicated by the red light flashing at a fast rate. If this occurs, re-insert battery pack. If

problem persists, try a different battery pack to determine if the charger is OK. If the new pack

charges correctly, then the original pack is defective and should be returned to a service center for

recycling. If the new battery pack gives the same trouble indication as the original, have charger

tested at an authorized service center.

Wall Mounting (Figure 2)

A hole is provided in the center of the charger for

mounting on a vertical surface.

Leaving the Battery Pack in the Charger

The charger and battery pack can be left connected

with the red light glowing indefinitely. The charger will

keep the battery pack fresh and fully charged.

NOTE: A battery pack will slowly lose its charge when kept out of the charger. If the battery

pack has not been kept on maintenance charge, it may need to be recharged before use. A

battery pack may also slowly lose its charge if left in a charger that is not plugged into an

appropriate AC source.

Important Charging Notes

1. Longest life and best performance can be obtained if the battery pack is charged when the

air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the battery pack in

an air temperature below +40°F(+4.5°C), or above +105°F (+40.5°C). This is important and

will prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to touch while charging. This is a

normal condition, and does not indicate a problem.

3. If the battery pack does not charge properly — (1) Check power at receptacle by

plugging in a lamp or other appliance. (2) Check to see if receptacle is connected to a light

switch which turns power off when you turn out the lights. (3) Move charger and

battery pack to a location where the surrounding air temperature is approximately

65°F - 75°F (18°- 24°C). (4) If charging problems persist, take or send the tool, battery

pack and charger to your local service center.

4. The battery pack should be recharged when it does not produce sufficient power on jobs

which were easily done previously. DO NOT CONTINUE use under these conditions.

Follow the charging procedures. You may also charge a partially used pack whenever you

desire with no adverse affect on the battery pack.

5. Black & Decker battery packs that are labeled “NiMH” should only be used with chargers

labeled “NiMH“ or “NiCd/NiMH.”

6. Under certain conditions, with the charger plugged into the power supply, the exposed

charging contacts inside the charger can be shorted by foreign material. Foreign

materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or

any buildup of metallic particles should be kept away from charger cavities. Always unplug

the charger from the power supply when there is no battery pack in the cavity. Unplug

charger before attempting to clean.

7. Do not immerse charger in water or any other liquid.

This Class B digital apparatus complies with Canadian ICES-003.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equip-

ment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment. This Class B digital

apparatus complies with Canadian ICES-003.

THE RBRC™ SEAL

The RBRC™ (Rechargeable Battery Recycling Corporation)

Seal on the nickel-cadmium battery (or battery pack) indicates that the costs to

recycle the battery (or battery pack) at the end of its useful life have already been

paid by Black & Decker. In some areas, it is illegal to place spent nickel-cadmium batteries in

the trash or municipal solid waste stream and the RBRC program provides an environmentally

conscious alternative.

RBRC in cooperation with Black & Decker and other battery users, has established programs

in the United States and Canada to facilitate the collection of spent nickel-cadmium batteries.

Help protect our environment and conserve natural resources by returning the spent nickel-

cadmium battery to an authorized Black & Decker service center or to your local retailer for

recycling. You may also contact your local recycling center for information on where to drop off

the spent battery, or call 1-800-8-BATTERY.

Important

This product is not user serviceable. There are no user serviceable parts inside the charger.

Servicing at an authorized service center is required to avoid damage to static sensitive

internal components.

READ ALL OF THE INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO

CHARGE THE BATTERY PACK FOR YOUR TOOL.

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be

performed by certified service centers or other qualified service organizations, always using

identical replacement parts.

Service Information

All Black & Decker Service Centers are staffed with trained personnel to provide customers

with efficient and reliable power tool service. Whether you need technical advice, repair, or

genuine factory replacement parts, contact the Black & Decker location nearest you. To find

your local service location, refer to the yellow page directory under "Tools—Electric" or call: 1-

800-544-6986 or visit www.blackanddecker.com

FULL TWO-YEAR HOME USE WARRANTY

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or

workmanship. The defective product will be replaced or repaired at no charge in either of two

ways.

The first, which will result in exchanges only, is to return the product to the retailer from whom it

was purchased (provided that the store is a participating retailer). Returns should be made

within the time period of the retailerʼs policy for exchanges (usually 30 to 90 days after the

sale). Proof of purchase may be required. Please check with the retailer for their specific return

policy regarding returns that are beyond the time set for exchanges.

The second option is to take or send the product (prepaid) to a Black & Decker owned or

authorized Service Center for repair or replacement at our option. Proof of purchase may be

required.Black & Decker owned and authorized Service Centers are listed under

"Tools-Electric" in the yellow pages of the phone directory.

This warranty does not apply to accessories. This warranty gives you specific legal rights and

you may have other rights which vary from state to state or province to province. Should you

Catalog No. F

SMVC

CAT. NO. FSMVC FORM NO. 90563677 REV. 1 MAY 2010

EA EL ESPAÑOL EN LA CONTRAPORTADA.

INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE

GARANTÍA.

AADDVVEERRTTEENNCCIIAA::

LÉASE ESTE INSTRUCTIVO ANTES DE USAR

EL PRODUCTO.

INSTRUCTION MANUAL

ig.1

MOUNTING HOLE

Fig.2

hank you for choosing Black & Decker!

Go to www.BlackandDecker.com/NewOwner

o register your new product.

LEASE READ BEFORE RETURNING THIS

RODUCT FOR ANY REASON:

If you have a question or experience a problem with your Black & Decker purchase, go to

TTP://WWW.BLACKANDDECKER.COM/INSTANTANSWERS

If you can’t find the answer or do not have access to the internet,

call 1-800-544-6986 from 8 a.m. to 5 p.m. EST Mon. -- Fri. to speak with an agent.

Please have the catalog number available when you call.

or instant answers 24 hours a day.

SSAAVVEE TTHHIISS IINNSSTTRRUUCCTTIIOONN MMAANNUUAALL FFOORR FFUUTTUURREE RREEFFEERREENNCCEE..

1 2 3 4

Résumé du contenu

Page 1 - INSTRUCTION MANUAL

Important Safety Instructions• SAVE THESE INSTRUCTIONS. This manual contains important safety and operatinginstructions for SPMVC battery charger.•Bef

Page 2 - MODE D’EMPLOI

have any questions, contact the manager of your nearest Black & Decker Service Center.This product is not intended for commercial use.FREE WARNING

Page 3 - MANUAL DE INSTRUCCIONES

Cette garantie ne sʼapplique pas aux accessoires. Cette garantie vous accorde des droitslégaux spécifiques et vous pourriez avoir dʼautres droits qui

Page 4 - ECCI N

ESPECIFICACIONESCargador:INPUT: 120 V AC 60 HZ0.7 AMPS (NOM 0,7 A)OUTPUT: 0.8 AMPS DC (NOM 0,8 A)INFORMACIÓN DE MANTENIMIENTOTodos los Centros de ser

Commentaires sur ces manuels

Pas de commentaire

Black & Decker G730 Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Chargeurs de batterie Black & Decker G730. Black & Decker G730 Instruction manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Chargeurs de batterie Black & Decker G730